Specifications

VX-3R OPERATING MANUAL58
MEMORY SCANNING
Memory scanning is also easy to initiate:
1. Set the radio to the Memory mode by pressing the
[
V/M
]
key, if necessary.
2. Press and hold in the
[
BAND
]
key for one second, and rotate the
DIAL knob while holding in the
[
BAND
]
key to select the de-
sired Memory Scan mode. Available selections are
ALL CHALL CH
ALL CHALL CH
ALL CH,
TAG1TAG1
TAG1TAG1
TAG1,
TAG2TAG2
TAG2TAG2
TAG2,
BANDBAND
BANDBAND
BAND, and
PMS-XPMS-X
PMS-XPMS-X
PMS-X.
ALL CHALL CH
ALL CHALL CH
ALL CH: The scanner sweeps all Memory channels.
TAG1TAG1
TAG1TAG1
TAG1: The scanner sweeps only those Memory channels with the same first digit of
the alpha/numeric tag as the first channel on which scanning started.
TAG2TAG2
TAG2TAG2
TAG2: The scanner sweeps only those Memory channels with the same first and
second digits of the alpha/numeric tag as the first channel on which scanning
started.
BANDBAND
BANDBAND
BAND: The scanner sweeps only those Memory channels which are memorized on
the same operating band as the first channel on which scanning started.
PMS-XPMS-X
PMS-XPMS-X
PMS-X: The scanner will sweep frequencies within the currently-selected PMS fre-
quency pair. See page 61 for details.
Note: Do not forget to pull the DIAL knob to rotate the DIAL knob.
3. Release the
[
BAND
]
key to initiate scanning.
4. As with VFO scanning, the scanner will halt on any signal encountered that is strong
enough to open the squelch; it will then resume scanning accord-
ing to the Scan-Resume mode set previously. When there are no
memory channels corresponding to the selected Memory Scan
mode, the “
MS ERRMS ERR
MS ERRMS ERR
MS ERR” notation will appear on the display.
5. To cancel scanning, press the PTT switch or
[
V/M
]
key.
SCANNING