Service manual

PWC – 500/1000/1010/1500

PureWaterCooler

The sanitization procedure is performed to reduce/eliminate any bacteriological

growth in the cooler tanks and dispensing plumbing. Bacteriological growth

can be the cause of some taste and odor in the water.

The procedure is as follows:

• Mix 1 teaspoon of common household bleach (5.25%) in 2 gallons of

clean water.

• Unplug the cooler from the power source.

• Drain all water from the cooler tanks.

• Pour the sanitizing solution into the main (cold temperature) tank until full.

• Open all spigots to allow sanitizing solution to fill the dispensing faucets.

Close the spigots.

• Let the sanitizing solution stand in the cooler for 10 minutes.

CAUTION: Leaving the sanitizing solution in the cooler for more

than 10 minutes can cause taste problems in the water.

• Completely drain the sanitizing solution from all the tanks per section 10

• Fill the main (cold temp.) tank with clear tap water to rinse out the

sanitizing solution.

• Completely empty the rinse water from the tanks.

• The cooler is now sanitized and ready for filling with filtered water.

12. Sanitization Procedure