Owner`s manual

- 11 -
CHAPTER 2: Basics
Installing Your Illumina SR
SOCKET ANCHOR (CEILING/FEMALE)
The Female side of the Socket Anchor is the
basepointforsuspendingthexture.Inorderto
mount this part, you will need a sturdy surface
(such as a wooden crossbeam – please refer to
the weight chart and consult with an expert prior
to installation) and an appropriate screw/bolt of
at least 2” in length.
Be sure that the head of the fastener is not larg-
er than the inner diameter of the anchor and
afxasshown.
When setting the anchors, consideration must
betakenintoaccountforthelengthofthextureandthewidthbetweenthe(adjustable)suspension
bridges. See the following table for optimal spacing between each suspension bridge:
MODEL
SR 300
SR 600
SR 900
SR 1200
SR 1500
SR 1800
SUSPENSION BRIDGE SPACING
(Centered Positioning)
110mm 4.25”
410mm 16.1”
610mm 24.0”
1010mm 39.75”
1310mm 51.5”
1610mm 63.4”
With the female Socket Anchors properly spaced
and installed, you will now be able to thread the
male adapters in, completing the mounting pro-
cess.
Draw the cables through the cable clamps as de-
sired. A leveling ruler is recommended to achieve
perfect horizontal balance.
Beforepoweringupthexture,ensurethatthe
unit and surrounding area are free of dust and
humidity.