User's Manual

5 WARNING

Federal Communication Commission Interference Statement

15.19

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this

device may not cause harmful interference, and (2) this device must accept any interference received, including

interference that may cause undesired operation.

15.105

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part

15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a

residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not

installed and used in accordance with the instructions, may cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a particular installation. If this equipment does

cause harmful interference to radio or television reception, which can be determined by turning the equipment

off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

—Reorient or relocate the receiving antenna.

—Increase the separation between the equipment and receiver.

—Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

—Consult the dealer or an experienced radio/TV technician for help.

FCC RF Radiation Exposure Statement:

This module is intended for OEM integrator. The OEM integrator is still responsible for the FCC compliance

requirement of the end product, which integrates this module. 20cm minimum distance has to be able to be

maintained between the antenna and the users for the host this module is integrated into. Under such

configuration, the FCC radiation exposure limits set forth for an population/uncontrolled environment can be

satisfied.

Any changes or modifications not expressly approved by the manufacturer could void the user's authority to

operate this equipment. The module has been tested for compliance to FCC Part 15.247.

USERS MANUAL OF THE END PRODUCT:

In the users manual of the end product, the end user has to be informed to keep at least 20cm separation with

the antenna while this end product is installed and operated. The end user has to be informed that the FCC

radio-frequency exposure guidelines for an uncontrolled environment can be satisfied. The end user has to also

be informed that any changes or modifications not expressly approved by the manufacturer could void the user's

authority to operate this equipment.

If the size of the end product is smaller than 8x10cm, then additional FCC part 15.19 statement is required to be

available in the users manual:

This device complies with Part 15 of FCC rules. Operation is subject to the following two conditions: (1) this

device may not cause harmful interference and (2) this device must accept any interference received, including