Programming instructions

/M/66-123
DXP Plus Programming Instructions
8.1.15
Disconnect Supervision
Description:
When you enable this feature, the system detects a break in loop current anytime one occurs
during an outside call.
Programming: 1 a Press CONTROL T for main menu.
2. From main menu, select lines and press ENTER.
3. From lines menu, select line programming and press ENTER.
4. Type line port number (l-240) or name and press ENTER.
5. From line programming menu, type item number for feature and press ENTER.
6. Press SPACE bar for feature setting.
7. When finished, press ESCAPE twice.
8. Type y to accept changes, n to reject them, or r to resume editing and press ENTER.
9. Repeat steps 4-8 for each line port or press ESCAPE to end.
8.1.16
Caller ID Active
Description: When caller identification (ID) information is available from the central office, take this
programming action to match the line port to the feature. You must also assign the caller ID
lines to the stations and assign special-purpose station buttons to control the feature. Refer to
Section 14. I for complete caller ID programming details.
Programming: 1 0 Press CONTROL T for main menu.
2. From the main menu, select lines and press ENTER.
3. From the lines menu, select line programming and press ENTER.
4. Type line port number (l-240) or name and press ENTER.
5. From the line programming menu, type item number for feature and press ENTER.
6. Press SPACE bar for feature setting.
7. When finished, press ESCAPE twice.
8. Type y to accept changes, n to reject them, or r to resume editing and press ENTER.
9. Repeat steps 4 through 8 for each line port or press ESCAPE to end.
10. Assign caller ID lines to stations-refer to Sections 7.1.31 and 7.1.32 for d+ails.
11. Assign caller ID button (mnemonic CID) to stations-refer to Section 7.3 for details.
12. Assign SAVE button (mnemonic SAVE) to stations-refer to Section 7.3 for details
6-10 Line Features Programming