Programming instructions

lM166-123
DXP Pius Programming hsfruefions
8.4.3
DIDlDNlS Programming
Programming: 1.
2.
3.
4.
5.
6.
Press CONTROL T for main menu
From the main menu, type the selection for lines and press ENTER.
From the lines menu, type the selection for DID/DNIS block programming
and press ENTER.
From the DID/DNIS block prompt line, type the DID/DNIS block number
and press ENTER.
From the DID/DNIS block programming menu, select options, and press ENTER
From the options menu, set the parameters for the DID/DNIS block that you are
programming:
NZUllt3
Type up to seven characters and press ENTER.
NOTE: End the DID/DNIS block name with a space if you desire a blank space between the
name and the CO digits when they show on an LCD speakerphone’s display. Also, the
number of CO digits that will show in the display is dependent on the length of the
DID/DNIS block name.
Control Signalling
Press SPACE bar for protocol choice and press ENTER.
Expected Digits
Type quantity (O-7) of digits and press ENTER.
Dialing Mode
Press SPACE bar for choice and press ENTER.
AN1 Delivery
Press SPACE bar for Yes or No and press ENTER.
DISA Voice Options Type DVA message identification number (l-4) and press ENTER.
Alternate Routing
Type intercom number (up to four digits) for station to handle
misdialed calls.
Ring Code
Type code (1-8) to specify the ringing pattern for calls to the
alternate station.
7. When finished, press ESCAPE.
8. Type y to accept changes, n to reject them, or r to resume editing
then press ENTER to return to the DID/DNIS block programming menu.
iVOTE: If you save the changes and you have changed the expected digits value, additional
prompts may appear.
6-16 Line Fea%ures Programming