Programming instructions

IM166-123
BXP PIUS Programming hsPfi.dof9s
DID Translation Tables Programming
Programming:
1~ Press CONTROL T for main menu.
2. From the main menu, type the selection for lines and press ENTER.
3. From the lines menu, type the selection for DID/DNIS block programming
and press ENTER.
4. From the DID/DNIS block prompt line, type the DID block number and press ENTER.
5. From the DID/DNIS block programming menu, select initialize translation table,
and press ENTER,
NOTE: Ifyou choose the initialize translation table entry, the system will prompt you to enter a
range of CO digit strings (system maximum is 400 strings and maximum digits per string
is seven) and a starting extension number corresponding to the first CO digit string*
Once you confirm your changes, the system will update the translation table with
sequential extension numbers that are associated with the sequence of CO digit strings.
You can repeat this process, as needed, for other sequences of numbers.
6. When finished, press ESCAPE to return to the DID/DNIS block programming menu.
7. From the DID/DNIS block programming menu, select edit translation table,
and press ENTER.
The screen shows a translation table in which you can perform selective editing.
NOTE: If there are more numbers in the DID/DNLS block than the screen can show9
the system
places them on underlying pages.
Press and hold CONTROL and type N or P to display
each next or previous page. The tab/e will form the screen so the CO digits are
displayed in sequential order. You can add additional entries to the end of the table
that
will appear in sorted order the next time you access the table.
8. When finished, press ESCAPE twice
9. Type y to accept changes, n to reject them, or r to resume editing and press ENTER.
10. Press ESCAPE three times to return to main menu.
You can erase the entries in the translation table using the system default menu.
1 e From the main menu, select system and press ENTER.
2. From the system menu, select defaults, and press ENTER.
3. From the defaults menu, select DID translation tables and press ENTER.
4. Type the DID/DNIS block number (1-Q and press ENTER. The system automatically
removes all entries in the chosen table.
5. Press ESCAPE twice to return to main menu.
DIDiDNIS Translation Table, Default
Description:
You can clear programmed translation tables with this procedure.
Programming;
1. Press CONTROL T for main menu.
2. From main menu, select system and press ENTER.
3. From system menu, select defaults and press ENTER.
4. From defaults menu, select DID translation table and press ENTER.
5. Type DID/DNIS table number (l-4) and press ENTER.
6. Repeat step 5 until finished.
7. Press ESCAPE to end.
8-20 Line Features Programming