Programming instructions

/M/66-123
DXP Plus Programming Instructions
10.3‘3
Account Code Lengfh
Description:
An account code can be a minimum of three digits or a maximum of 16 digits.
Use this
procedure to set the amount of account code digits.
NOTE: If you change the account code length you will delete
all currently programmed account codes.
Programming:
1. Press CONTROL T for main menu.
2. From main menu, select SMDAISMDR and press.
3. From SMDAKMDR menu, select SMDABMDR parameters and press ENTER.
4. From SMDABMDR parameters menu, type item number for feature and press ENTER.
5. Type the account digit amount (3-16).
6. When finished, press ESCAPE twice.
7. Type y to accept changes, n to reject them, or r to resume editing and press ENTER to end.
10.3.4 Account Code Programming (Add, Remove, Display Acwunf Codes)
Description: Use this procedure to assign up to 1000 account codes (each up to 16 digits in length-see
Section 103.3). Alternately, use this procedure to remove previously assigned account codes
from the system.
Add or remove one account code at a time or an entire block of account codes
all at once. To assign numbers that user’s can dial without entering an account code,
refer to Section 10.4.
Programming:
1. Press CONTROL T for main menu.
2. From the main menu, select SMDAISMDR and press ENTER.
3. From SMDABMDR menu, select account code menu and press ENTER.
4. From account code menu, type item number to add or remove one account
code or a block of account codes and press ENTER.
5. Type account code (up to 16 digits) and press ENTER. Then, if
assigning block of codes, type quantity of account codes (up 1000) and press ENTER
6. When finished, press ESCAPE once.
7. Type item number to display account codes for review and press ENTER.
8. When finished press ESCAPE as necessary to return to main menu.
10-12 CaH Costing and SMBAfSMDR Programming