Programming instructions
DXP
Plus
Programming
instructions
lMl66-123
12.2
ARS Enable
Description:
You can enable or disable automatic route selection on a system-wide basis. A defaulted
system has ARS disabled.
Programming:
1~
Press CONTROL T for main menu.
2. From main menu, select system and press ENTER.
3. From the system menu, select system parameters and press ENTER.
4. From the system parameters menu, select ARS feature and press ENTER.
5. Press SPACE BAR to toggle between enable and disable.
6.
Press ESCAPE twice.
7. Type y to accept changes, n to reject them, or r to resume editing and press ENTER to end.
12.3
Line Groups for ARS
Description:
Before automatic route selection can operate, you must group similar lines together into line
groups. The system can have a total of 16 line groups with unlimited lines in each group.
Be sure that you program similar line types together into the same line groups to take advantage
of the efficiency and cost savings associated with automatic route selection. Some examples of
lines that have similar characteristics and should be grouped together into line groups are as
listed below:
-
outgoing WATS lines to a particular area,
-
FX lines to a frequently called area,
-
similar AT&T long distance lines,
-
similar MCI lines,
A line group can consist of only one line, (for example, if only one FX line exists, put it into a
separate line group). Doing this allows the ARS feature to route calls over that group (FX line)
for any calls to the FX line area.
NOTE: To prevent system users from accessing non-ARS line groups, use the Section 6.12
procedure to clear the dialing codes for all non-ARS line groups.
Programming:
1.
Press CONTROL T for main menu.
2.
From main menu, select lines and press ENTER.
3.
From the lines menu, select line group programming and press ENTER.
4.
Type line group number (1-16) and press ENTER.
5.
Type a to add lines, r to remove lines, or c to change name of line group and press ENTER.
6.
Type line to be removed, added, or changed then press ENTER.
7.
Type y to accept changes, n to reject them, or r to resume editing and press ENTER.
8.
Repeat steps 4-7 for each line port or press ESCAPE to end.
Automatic Route Selection Programming 12-3