Programming instructions

DXP Plus Programming Instructions lM66-123
Programming Modifv Digit Tables
Description:
Use this procedure to program the modify digit table.
Programming:
1. Press CONTROL T for main menu.
2. From the main menu, select TOLL/ARS and press ENTER.
3. From the TOLL/ARS menu, select modify digit table and press ENTER.
4. Type line number for modify digit table to be programmed and press ENTER.
5. Press TAB key to position cursor at digits to delete column.
6. Type &lo for number of digits to delete.
7. Press TAB key to position cursor at digits to add column.
8. Type digits to add (O-9, pause). A maximum of 20 digits can be entered.
9. Press TAB key to position cursor for next modify digits table.
10. Repeat steps 6-9 until all modify tables are entered and press ENTER.
11. When finished, press ESCAPE twice.
12. Type y to accept changes, n to reject them, or r to resume editing and press ENTER to end.
13. Press ESCAPE to return to main menu.
Assigning Modify Digit Table To Route
Description:
Use this procedure to assign modify digit tables to routes.
Programming: 1. Press CONTROL T for main menu.
2. From the main menu, select TOLL/ARS and press ENTER.
3. From the TOLL/ARS menu, select route table and press ENTER.
4. Type l-32 to select route table to be programmed and press ENTER.
5. Type l-6 to select route number and press ENTER.
6. Press TAB key to position cursor at modify table column.
7. Type 1-16 ENTER to choose modify digit table needed.
8. Press ESCAPE and repeat steps 5 through 8 for all six routes.
9. When finished, press ESCAPE.
10. Type y to accept entries, n to reject them, or r to resume editing and press ENTER.
12. Repeat steps 4-l 1 for all needed route tables or press ESCAPE to end.
13. Press ESCAPE twice to return to main menu.
Automatic Route Selection Programming 12-9