Programming instructions

6.3
Messaging
6.3. I
LCD Messaging
Description:
This procedure enables a class of service messaging feature. It allows station users to set a
message at their stations that will be displayed on calling LCD speakerphones. You can use the
second part of this procedure to program the actual LCD messages. Alternately, The attendant
can program the LCD messages using procedures found in the attendant guide.
Also refer to Section 6.3.2.
Programming:
To enable feature for class of service,
1. Press CONTROL T for main menu.
2. From main menu, select stations and press ENTER.
3. From stations menu, select COS programming and press ENTER.
4. Type class of service number (l-32) and press ENTER.
5. From COS programming menu Type item number for feature and press ENTER.
6. Press SPACE bar for feature setting.
7. When finished, press ESCAPE twice.
8. Type y to accept changes, n to reject them, or r to resume editing and press ENTER.
9. Repeat steps 4-8 for each COS or press ESCAPE to end.
To program LCD Messages,
1. Press CONTROL T for main menu.
2. From main menu, select system and press ENTER.
3. From system menu, type item number for feature and press ENTER.
4. From LCD messages menu, type selection (l-10) and press ENTER.
5. Type message and press ENTER. Message can be 16 characters long.
6. Repeat steps 4 and 5 for all messages. Press CONTROL N for more LCD message lines.
7. When finished, press ESCAPE twice.
8. Type y to accept changes, n to reject them, or r to resume editing and press ENTER.
Operation:
Turn message on: press INTERCOM, dial + 02, then dial message code (01 through 30) #.
Turn Message off: press INTERCOM, dial # 02.
System Features Programming 6- 7