Programming instructions
/M/66-123
DXP Plus Programming Instructions
6.4. I
Matching Serial Data Port Numbers
To Communications Card Locations
Description:
You must take this programming action to match the serial data ports
%
l-18 with the
installation location that you choose for the communications cards.
Programming:
1.
Press CONTROL T for main menu.
2.
From main menu, select systems and press ENTER.
3.
From system menu, select system parameters and press ENTER.
4.
From system parameters menu, type item number for feature and press ENTER.
5.
Press SPACE bar for communications card board location
and press ENTER to accept setting.
6.
When finished, press ESCAPE twice.
7.
Type y to accept changes, n to reject them, or r to resume editing and press ENTER.
6.4.2
Setting Serial Data Port Parameters
Description:
You can change the baud rates, data bits, stop bits, parity, and flow control for each serial data
port in the system to match the data device that you connect there.
Programming:
1.
Press CONTROL T for main menu.
2.
From main menu, select system and press ENTER.
3.
From system menu, select serial ports and press ENTER.
4.
From serial ports menu, type item number for main port, services port, or for auxiliary port
and press ENTER.
NOTE: The
system will not respondfor services or auxiliary
ifyou
do not have communications
cards installed on the services or auxiliary boards
5.
From serial port type menu, select the serial port number and press ENTER.
6.
Press SPACE bar for feature setting
7.
Press TAB for next parameter.
8.
Repeat steps 6 and 7 for all parameters.
9.
Press ENTER to accept settings.
10. When finished, press ESCAPE twice.
11. Type y to accept changes, n to reject them, or r to resume editing and press ENTER.
12. Press ESCAPE to end.
6-10
Sys
tern
Features Programming