Programming instructions

/M/66-123
DXP Plus Programming Instructions
6.8.6
Paging Access
Description:
If you have assigned a paging zone and given that zone access to external paging equipment
(Section 6.101) plus enabled paging transmit capability (see Section 6.10.3) at a station, that
station has access to external paging equipment. With this paging access procedure, you can set
the maximum length of time that a station can stay connected to the external paging equipment.
This timing setting also controls the amount of time a station can stay connected to the system
zone paging.
Programming:
1. Press CONTROL T for main menu.
2. From main menu, select system and press ENTER.
3. From system menu, select timing and press ENTER.
4. From system timing menu, type item number for feature and press ENTER.
5. Press SPACE bar for feature setting and press ENTER to accept setting.
6. When finished, press ESCAPE twice.
7. Type y to accept changes, n to reject them, or r to resume editing and press ENTER.
6.8.7
Pause Time
Description: During speed dialing, it is sometimes necessary to have the system delay the sending of digits to
give host system switching equipment time to prepare to receive them. A pause, stored in the
speed dial number, provides this delay. This programming procedure determines the duration of
the pause. The person who stores the speed dial number must press the telephone’s HOLD
button at the point in the number digit sequence where he or she needs the pause (for example,
g-pause-1 8049782200). See Section 6.7 for speed dial programming.
Programming:
1 s Press CONTROL T for main menu.
2. From main menu, select system and press ENTER.
3. From system menu, select timing and press ENTER
4. From system timing menu, type appropriate line number and press ENTER
5. Press SPACE bar for feature setting and press ENTER to accept setting.
6. When finished, press ESCAPE twice.
7. Type y to accept changes, n to reject them, or r to resume editing and press ENTER..
6.8.8
Recall/Flash
Description: A station can generate either a line disconnect signal (recall) or a host system feature access
signal (flash) when its user presses the telephone’s TAP button Use this procedure to arrange
for either the recall or the flash signal.
Programming: 1. Press CONTROL T for main menu.
2. From main menu, select system and press ENTER.
3. From system menu, select timing and press ENTER.
4. From timing menu, type item number for feature and press ENTER.
5. Press SPACE bar for feature setting and press ENTER.
6. When finished, press ESCAPE twice.
7. Type y to accept changes, n to reject them, or r to resume editing and press ENTER.
6-18 System Features Programming