Programming instructions
DXP Plus Programming Instructions
/M/66-123
6.8.9
Periodic Tone Time
Description: After you enable the periodic warning tones that remind users to keep conversations short on
certain outside lines (Section
7.1.33),
use this procedure to set how often that you wish the
periodic warning tones to occur
Programming:
1. Press CONTROL T for main menu.
2. From main menu, select systems and press ENTER.
3. From system menu, select timing and press ENTER.
4. From system timing menu, type item number for feature and press ENTER.
5. Press SPACE bar for feature setting and press ENTER to accept setting.
6. When finished, press ESCAPE twice.
7. Type y to accept changes, n to reject them, or r to resume editing and press ENTER.
6.8.
IO
Maximum Call Duration
(Time)
Description:
After you enable the maximum call duration feature
(Section
7. I
.34),
use this procedure to set
the cut off time.
Programming:
1. Press CONTROL T for main menu.
2. From main menu, select systems and press ENTER.
3. From system menu, select timing and press ENTER.
4. From system timing menu, type item number for feature and press ENTER.
5. Press SPACE bar for feature setting and press ENTER to accept setting.
6. When finished, press ESCAPE twice.
7.
Type y to accept changes, n to reject them, or r to resume editing and press ENTER.
6.8.11
Internal lnterdigit Dialing
Description:
A timer starts running with the dialing of each digit during intercom number dialing. It also
starts running whenever the user accesses the intercom number path and does not dial any
digits. When the timer times out, the system returns the station to an idle state. Use this
procedure to set the intercom dialing
timout
period for the entire system.
Programming:
1. Press CONTROL T for main menu.
2. From main menu, select system and press ENTER.
3. From system menu, select timing and press ENTER.
4. From system timing menu, type item number for feature and press ENTER.
5. Press SPACE bar for time and press ENTER.
6. When finished, press ESCAPE twice.
7. Type y to accept changes, n to reject them, or r to resume editing.
8. Press ENTER to end.
System Features Programming
6-
19
: