Programming instructions

/M/66-123 BXP Plus Programming Instructions
6.8.12
Line-To-Line Connect Duration
Description:
After you have given a station the ability to set up an unsupervised conference between two
lines (Section ZI.37), you should use this procedure to set the maximum amount of time that an
unsupervised conference can continue between two lines. When the time out occurs, the system
recalls the station from where the user enabled the unsupervised conference.
Programming:
1~ Press CONTROL T for main menu.
2. From main menu, select system and press ENTER.
3. From system menu, select timing and press ENTER.
4. From timing menu, type item number for feature and press ENTER.
5. Press SPACE bar for feature setting and press ENTER.
7. When finished, press ESCAPE twice.
8. Type y to accept changes, n to reject them, or r to resume editing and press ENTER.
6.8.13
Camp-On/Automatic Call Back Ring
Description:
After you use Section 7. I.8 to enable a call waiting tone, use this procedure to set the duration
of the camp-on/automatic ringback ring that the system sounds when it returns a camp-on call to
the original station..
Programming: 1 D Press CONTROL T for main menu.
2. Form main menu, select system and press ENTER.
3. From system menu, select timing and press ENTER.
4. From the system timing menu, type item number for feature and press ENTER.
5. Press SPACE bar for time and press ENTER to accept setting.
6. When finished, press ESCAPE twice.
7. Type y to accept changes, n to reject them, or r to resume editing and press ENTER.
6.8.14
Out Dial Delav Time
Description:
The system will wait for a programmed length of time before sending automatically dialed
numbers over an outside line. This delay gives the host system time to return dial tone before
the system begins dialing the number. Different host systems require different periods of time
between when a line is picked up and when dial tone is returned. Use this procedure to match
this system to your host system.
Programming:
1. Press CONTROL T for main menu.
2. From main menu, select system and press ENTER.
3. From system menu, select timing and press ENTER.
4. From system timing menu, type item number for feature and press ENTER.
5. Press SPACE bar for feature setting and press ENTER.
6. When finished, press ESCAPE twice.
7. Type y to accept changes, n to reject them, or r to resume editing and press ENTER.
6-20 Sys tern Features Programming