Programming instructions

DXP Plus Programming Instructions
lMl66-123
6.12 Feature Renumbering
Description:
Dialing codes for user features are flexible so that you can renumber them. This may be
necessary if site requirements dictate that personal or group intercom numbers fall within a
certain block or sequence. Since new number assignments can not conflict with existing
number, the system provides a block of unassigned numbers that you can use for renumber
assignment. At default, the system assigns blocks of numbers in the following ranges:
1001-1480 = personal intercom,
4001-4480,5000-5039 = group intercom,
5040-5999 = unassigned,
600-899, f, # = feature codes
9 = line group 1
Programming:
1. Press CONTROL T for main menu.
2. From main menu, select system and press ENTER.
3. From system menu, select feature renumbering and press ENTER.
4. From feature renumbering menu, select feature catagory and press ENTER.
5. From feature catagory menu, type item number for feature and press ENTER.
6. Type new code and press ENTER.
NOTE: The number block of 504@5999 is unassigned at default. Use it for code renumbering.
7. When finished, press ESCAPE twice.
8. Type y to accept changes, n to reject them, or r to resume editing and press ENTER.
9. Press ESCAPE to end.
If a number conflict exists, the system will prompt you to remove the conflict. Before
responding to this prompt with a y (yes), be sure that doing so will not disturb other
programmed features that depend upon the removed extension number. It is possible
to create a situation where you must make several renumbering changes to completely
resolve a number conflict.
Sys tern Features Programming 6- 4 1