Programming instructions

7.1.37
Line-To-Line Transfer (Unsupervised Conference)
Description:
This programming feature gives a station the ability to set up an unsupervised conference
between two lines.
Programming:
1. Press CONTROL T for main menu.
2. From main menu, select stations and press ENTER.
3. From stations menu, select COS programming and press ENTER.
4. Type class of service number (l-32) and press ENTER.
5. From COS programming menu, type item number for feature and press ENTER.
6. Press SPACE bar for feature setting.
7. When finished, press ESCAPE twice.
8. Type y to accept changes, n to reject them, or r to resume editing and press ENTER.
9. Repeat steps 4-8 for each COS or press ESCAPE to end.
Line-To-Line Connect Duration
Description:
After you have given a station the ability to set up an unsupervised conference between two
lines, use this procedure to set the maximum amount of time that an unsupervised conference
can continue between two lines. When the time out occurs, the system recalls the station from
where the user enabled the unsupervised conference.
Programming: 1. Press CONTROL T for main menu.
2. From main menu, select system and press ENTER.
3. From system menu, select timing and press ENTER.
4. From timing menu, type item number for feature and press ENTER.
5. Press SPACE bar for feature setting and press ENTER.
7. When finished, press ESCAPE twice.
8. Type y to accept changes, n to reject them, or r to resume editing and press ENTER.
Sfa tion Features Programming 7-27