Programming instructions

/M/66-123
DXP Plus Programming Instructions
7.1.36
Voice Announce Block
Description:
When you enable this programming feature a station has the ability to block voice announced
internal signalling when its user dials the proper code.
Programming:
1. Press CONTROL T for main menu.
2. From main menu, select stations and press ENTER.
3. From stations menu, select COS programming and press ENTER.
4. Type class of service number (l-32) and press ENTER.
5. From COS programming menu, type item number for feature and press ENTER.
6. Press SPACE bar for feature setting.
7. When finished, press ESCAPE twice.
8. Type y to accept changes, n to reject them, or r to resume editing and press ENTER.
9. Repeat steps 4-8 for each COS or press ESCAPE to end.
Operation:
On: INTERCOM +t+ 2
Off: INTERCOM # 2
7.1.39 Infernal /ST Hash
Description:
If industry-standard telephone users access an outside line using the line group feature and then
quickly press and release (flash) the telephone’s hookswitch, the IST will react in one of two
different ways depending upon how you program this feature. Refer to Section 72.35 for other
IST programming considerations.
q With this feature disabled, IST users can flash the hookswitch while on an outside line and
generate a hookflash signal on the outside line; however, they cannot flash the hookswitch
to obtain an intercom dial tone. The Section 7.2.35 procedure sets the hookflash signal time.
This time determines whether the IST hookflash signal is long enough to recall the outside
line dial tone or short enough to access the outside line features. Refer to the CO
specifications for actual requirements.
q With this feature enabled, IST users can flash the hookswitch while on an outside line and
obtain intercom dial tone; however, they must dial + 08 after they flash the hookswitch if
they need to generate a hookflash signal on the outside line.
Programming:
1. Press CONTROL T for main menu.
2. From main menu, select stations and press ENTER.
3. From stations menu, seIect COS programming and press ENTER.
4. Type class of service number (l-32) that corresponds with class of service assigned
to the IST and press ENTER.
5. From COS programming menu, type row number for IST distinctive ringing
and press ENTER.
6. Press SPACE bar for feature setting.
7. When finished, press ESCAPE twice.
8. Type y to accept changes, n to reject them, or r to resume editing and press ENTER.
9. Press ESCAPE to end.
7-28 Station Features Programming