Installation guide

Configuring private networking 9-33
Chapter 9: Configuring Outbound Call Routing
Wave Global Administrator Guide
10 Click in the Routing Table column and select one of the following from the drop-down list:
• A routing table that has already been defined.
•
*Blocked*. Select this option to block all calls to the area or office codes.
•
(New Routing Table). Select this option to open the Routing Table dialog. See
“Configuring outbound routing tables” on page 9-20 for instructions.
11 Click
OK to return to the Outbound Routing table.
12 Click
Done to save your changes and return to the Management Console.
Configuring the First Digit Table for private networking
You need to specify which first digit to use to access private networking.
To configure the First Digit Table for private networking
1 If necessary, click the Administration tab of the Management Console.
2 Click the First Digit Table icon, located in the PBX Administration section.
Click
Release 2.0
September 2010