Installation guide

Configuring Caller ID 16-8
Chapter 16: PBX Feature Configuration
Wave Global Administrator Guide
• User-specific external Caller ID setting, if specified, overrides the system-wide
setting. The user-specific external Caller ID setting is set for the user via the
User/Group Management applet, User dialog \ External Caller ID tab.
By default, external Caller ID at the user-specific level uses the system-wide setting.
• Trunk-specific external Caller ID setting, if specified, overrides the user-specific
setting. By default, trunk-specific external Caller ID is not sent.
Trunk-specific external Caller ID can be set in two places:
• For outbound analog or digital trunks, external Caller ID is set via the Trunk
Groups applet, Out tab.
• For an outbound IP call destination, external Caller ID is set via the IP Telephony
applet. (Click
Call Routing > Signaling Control Points, edit the SCP, and then click
the Outbound Routing tab.)
Release 2.0
September 2010