Installation guide

Configuring network services and routing protocols 21-4
Chapter 21: Advanced Data Networking Configuration
Wave Global Administrator Guide
To configure RIP
1 Open the Microsoft RRAS applet under Data Administration on the General
Administration tab of the Management Console. Log on using your Wave username and
password. The Routing and Remote Access dialog opens.
For more information about logging in with a remote connection, see “Remote access
applets” on page 2-7.
2 Add the RIP protocol.
Right-click the General folder under IP Routing, and choose
New Routing Protocol. In the
New Routing Protocol dialog, click
RIP Version 2 for Internet Protocol and click OK.
3 Select each interface on which you want to enable the routing protocol.
Right-click RIP in the IP Routing folder and select
New Interface. Select the desired
interface, then click
OK. Configure the Internet properties for that interface on the dialog
that opens, then click
OK.
4 Close the Routing and Remote Access dialog to return to the Management Console.
Click
Release 2.0
September 2010