Installation guide

Applying HotFixes 7-3
Chapter 7: Initial Configuration
Wave Server Installation Guide
5. Do one of the following:
• To apply a single HotFix, click
Add and Start Upgrade. The HotFix is uploaded to
the Wave Server, and the upgrade process begins.
• To apply multiple HotFixes in the same upgrade, click
Add. Note that some time
may elapse while the HotFIX CAB file(s) are uploaded to the Wave Server. Repeat
step 5 for each HotFix to be loaded.
The HotFixes will be installed in the order listed. To re-order the list, select a
HotFix and then click
UP or DOWN. When you are satisfied with the list of
HotFixes, click the
Start button below the Upgrade List to initiate the upgrade.
Important: Unless otherwise specified, best practice is to load HotFixes in
numerical order and load any Add-on HotFixes last (for example, Call Navigator
HotFixes.)
6. Once the upgrade process starts, you will be alerted on the progress of the upgrade via the
SNMP Alarms applet. Minimize the SNMP Alarms window so that you can see the next
message.
7. When you see the following message, click
Done to close the Software Upgrade applet
and return to the Global Administrator Management Console.
“Upgrade Status Upgrade request successful. InstantOffice System upgrade will
start momentarily.”
8. Restore the SNMP Alarms window and monitor it until the “Rebooting InstantOffice”
entry appears. The Wave Server restarts one or more times, depending on the number of
restarts required by the HotFixes that you installed. Most HotFixes take 10 minutes or
more to install completely.
Note: HotFix installation is complete when the blink pattern of the red LED at the far
right of the ISC1 or ISC2 (depending on the Wave Server model) changes from a fast
double blink to a steady single blink.
9. Once the Wave Server restarts for the final time, log on again using your Wave user name
and password.
10. To verify that the HotFixes were applied successfully, click Software Versions in the
General Administration section of the Global Administrator Management Console. The
top entry shows the latest release. HotFix entries are listed in the order that they were
applied, using the following format:
[Day] [Date] [Year] [Time]= [HotFix information]
Release 2.0 Service Pack 1
April 2011