Installation guide

Setting the dial-in default IP address pool 7-11
Chapter 7: Initial Configuration
Wave Server Installation Guide
To restart the Wave Server after powering off:
1. On a Wave IP 2500, turn the power switch on the back of the Wave Server off, wait 30
seconds, and then turn the power switch on.
On a Wave IP 500, press the red button on the front panel.
2. When you observe the following pattern on the ISC1 or ISC2 LEDs, the system is fully
operational:
Note: For a detailed description of the system status LED sequence that is displayed
during system startup, see “Normal boot sequence indicators” on page C-3.
Setting the dial-in default IP address pool
Before the Wave ISM will allow dial-in connections, you must set the IP address pool for those
connections. Because this is an internal pool of addresses, obtain the appropriate settings from
your company’s system administration group.
All Wave ISMs ship with the same default IP address pool. Enabling a routing protocol such as
RIP or OSPF on the Wave ISM causes it to advertise a route to that address pool. If you choose
not to change the default IP address pool, each Wave ISM will advertise a route to the same IP
address pool, which may result in network problems.
SYSTEM STATUS LEDS CARD STATUS
LEDS
Current status Expected
time
LED1 LED2 LED3 LED4 Red
LED
Green
LED
System is fully
booted and
operational.
Indefinitely Green Alterna-
ting
flicker-
ing red
on green
back-
ground /
green
Slow
blinking
green
Blinking
green
off Blinking
green
Release 2.0 Service Pack 1
April 2011