Installation guide

Setting the dial-in default IP address pool 7-12
Chapter 7: Initial Configuration
Wave Server Installation Guide
To set the dial-in default IP address pool:
1. In the Global Administrator Management Console, click Microsoft RRAS, located in the
Data Administration section.
2. Log on using your Wave username and password.
3. The Microsoft RRAS applet launches the Microsoft Routing and Remote Access
application in a remote control window that allows the application running on the Wave
ISM to appear on the administrator PC. (For more information, see “Remote Access
Application applets” in Chapter 25 in the Wave Global Administrator Guide.)
Click
Yes if you are asked if you trust the computer to which you are connecting.
4. In the Routing and Remote Access dialog, select the Wave ISM in the tree in the left
pane.
5. Choose
Action > Properties.
6. On the IP tab, select
Static address pool.
7. Click
Add to define the IP address pool.
8. In the New Address Range dialog, enter the
Start IP address and End IP address.
Note: The IP address pool is defined with a range of IP addresses. The lowest two
addresses and the broadcast address (the highest address) in the range are reserved and will
never be assigned.
9. Click
OK to save your changes, and then return to the Global Administrator Management
Console.
Release 2.0 Service Pack 1
April 2011