Installation guide

Performing basic system configuration tasks 7-13
Chapter 7: Initial Configuration
Wave Server Installation Guide
Performing basic system configuration tasks
Important: If you configured Global Settings / General Settings via the Installation Wizard as
described in Chapter 6, you do not need to perform the steps in this section, unless you now
want to change any of those settings.
This section describes how to perform the following basic tasks:
• Enter basic system information. See page 7-13.
• Set the system date and time. See page 7-17.
• Configure the time service used by Wave ISM. See page 7-18.
Entering basic system information
Note the following about the information you enter according to the following instructions:
•
Company Name is used in your external caller ID.
•The Wave Server
Serial Number is used by the Software Licenses applet to verify that a
Wave software license is applied to the correct Wave ISM, and by Global Manager to
identify each Wave Server uniquely. Also, your Vertical technical support representative
may requests it while troubleshooting a problem.
•The
Locale that you specify enables appropriate locale-specific system settings including
ring cadence, minimum analog hook flash, tone set, line impedance, trunk locale, and so
forth.
•The
Voice Mail System defines the voice mail pilot number for the Wave ISM. The voice
mail pilot number is the extension users dial, or trunk groups use, to reach the voice mail
hunt group.
Release 2.0 Service Pack 1
April 2011