Installation guide

Performing basic system configuration tasks 7-18
Chapter 7: Initial Configuration
Wave Server Installation Guide
4. On the Time Zone tab, verify that the time zone is correct for your Wave ISM location,
and change it if necessary.
5. On the Date and Time tab, verify that the date and time are correct for your Wave ISM
location, and change them if necessary.
6. Click
OK to save your changes and return to the Global Administrator Management
Console.
Configuring the time service used by Wave ISM
This section describes how to specify a time server that is polled by the Wave ISM time service
to keep accurate time for Wave ISM components.
1. In the Global Administrator Management Console, click
General Settings, located in the
General Administration section. Click the Time Service tab.
2. Enter the domain names of the time servers you want to use in the
Primary Time Server
and
Secondary Time Server fields. Enter the full name of the time server. Two commonly
used time servers are time.nist.gov and tick.usno.navy.mil.
3. Enter the interval (in hours) between each time server poll in the
Synchronize Period
field.
Release 2.0 Service Pack 1
April 2011