Installation guide

Wave Server Installation Guide
Appendix C
Integrated Services Card Status LEDs
APPENDIX CONTENTS
Overview
The System Status LEDs and Card Status LEDs on the front of the Integrated Services Card
(
ISC1 or ISC2, depending on your Wave Server model) in your Wave Server provide valuable
troubleshooting information. When you contact your Vertical technical support representative,
you may be asked to describe the LED activity that you observe. You can view the Status LEDs
by physically examining the front of the
ISC1/ISC2 directly, or via the Chassis View applet in
the Global Administrator Management Console.
About Card LEDs
There are two Card Status LEDs, red and green, that indicate the general status of the Wave
Server:
Overview . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . C-1
System LED indicators. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . C-3
Status Red Card LED Green Card LED
System is in an early boot phase. off off
System boot is in progress, or a firmware flash
update is in progress.
Blinking red off
System is operational with no errors. off Blinking green
System shutdown is in progress. Blinking red Blinking green
Error condition exists on the system. Red off
Release 2.0 Service Pack 1
April 2011