Installation guide

Connecting a paging system 3-24
Chapter 3: Setting Up the Wave IP 500 Server
Wave Server Installation Guide
To connect a music-on-hold device:
1. Locate the audio input port (labeled Audio In) on the ISC2.
2. Connect the cable from your music-on-hold device to the port.
3. Enable music on hold in the General Settings applet of the Global Administrator
Management Console. See the Wave Global Administrator Guide for more information.
Connecting a paging system
A paging system allows Wave users to make public announcements over a loudspeaker.
The Wave Server is compatible with most standard paging systems that connect via a 3.5 mm
stereo plug. If a cable is not provided, you must purchase one separately.
Note: Although a stereo cable is required, only one channel is used for paging.
Caution: Always follow the instructions supplied by the manufacturer of your paging system
when installing and connecting the system to avoid possible injury to yourself or damage to the
equipment.
Release 2.0 Service Pack 1
April 2011