Installation guide

Mounting the Wave Server 4-9
Chapter 4: Setting Up the Wave IP 2500 Server
Wave Server Installation Guide
To wall mount the Wave Server base unit:
1. Prepare a piece of plywood that meets the following minimum dimensions for proper
ventilation and service access:
Thickness—0.75 inches (2 cm)
Height—24 inches (61 cm)
Width— 34 inches (86.4 cm)
2. Draw a vertical line on the plywood 4 inches (10.2 cm) from the left edge, and a
horizontal line 3-1/4 inches (8.3 cm) from the top edge:
3. Locate supporting studs in your wall, and firmly attach the prepared piece of plywood to
the studs using the appropriate screws.
4. If the mounting brackets are currently installed on the front of the Wave Server, remove
them.
Plywood
24"
34 “
(10.2 cm)
3 1/4"
(8.3 cm)
4”
Two lines
(61 cm)
(6.4 cm)
Release 2.0 Service Pack 1
April 2011