Installation guide

About connecting modules and cards 4-21
Chapter 4: Setting Up the Wave IP 2500 Server
Wave Server Installation Guide
Module and card status LEDs
Each module and card has a pair of LEDs that indicate the component’s status:
T1/E1 module alarm indicators
The T1 module with serial interface and E1 EuroISDN module with serial interface have
additional alarm indicators, one set for the T1/E1 port and one set for the serial port, located to
the left of the module status LEDs. See “Alarm indicators” in Chapter 15 in the Wave Server
Hardware Reference Guide for more information.
About connecting modules and cards
This section provides general information about connecting trunks, stations, and other devices
to modules and cards. Instructions for connecting specific modules and cards are described in
subsequent sections.
Important: Before connecting modules and cards, ensure that the following tasks have been
completed, depending on your configuration:
• The punchdown block or patch panel has been properly wired.
• Analog and T1 trunks have been installed by your service provider.
• Incoming analog DID trunks have been tested to ensure no voltage is present, as well as
to verify that they are DID trunks.
Status Red LED Green LED
System is in an early boot phase. off off
System boot is in progress, or a firmware flash
update is in progress.
Blinking red off
System is operational with no errors. off Blinking green
System shutdown is in progress. Blinking red Blinking green
Error condition exists on the system. Red off
System upgrade is in progress. Blinking red Green
Hard drive imaging in progress (via the Wave
System Recovery Disk.)
Red Green
Release 2.0 Service Pack 1
April 2011