Installation guide

About connecting modules and cards 4-22
Chapter 4: Setting Up the Wave IP 2500 Server
Wave Server Installation Guide
About cable connections
Modules and cards use standard cable connectors and jacks, as listed in the following table:
Note: Some modular connectors look alike. Verify that your cables use the standard connectors
specified for a particular card or module.
Connecting an RJ-21X cable
Important: In order to ensure a secure fit when connecting an RJ-21X (25-pair amphenol)
cable to a station or trunk module or card, you should use 3/4-inch 4-40 captive (partially
threaded) pan head screws. Be aware that some RJ-21X cables may come with screws that are
too short, and you should replace them with 3/4-inch screws.
Module or card RJ-11 RJ-21X RJ-45 RJ-48C 3.5 mm
audio
USB
Integrated Services
Card (ISC1)
11 2 2
Analog trunk module
1
Analog universal
module
1
Digital station module
1
T1 module with serial
interface
1
T1 module (without
serial interface)
1
E1 EuroISDN module
with serial interface
1
Quad BRI module
4
Analog station card
1
Digital station card
1
Release 2.0 Service Pack 1
April 2011