User Manual

Language 6
The Battery and SIM Card
THE BATTERY AND SIM CARD
If your Vertu phone was purchased at a Vertu store,
the battery and SIM card should have been
installed already. Otherwise, follow the procedure
below to install your battery and SIM card.
The SIM card and its contacts are easily damaged.
Be careful when handling, inserting or removing
the card.
> With the back of your Vertu phone facing you,
position the back cover release key (01) very
carefully into the slot of the locking screw (02).
Ensure the key does not slip out of the slot
> Turn the locking screw (02) a quarter of a turn
anticlockwise, and gently lift off the back cover as
shown. If you accidentally remove the back cover
while the phone is switched on, the phone will
automatically switch off.
Attach the back cover release key to your
keyring for convenience.
> Remove the plastic placeholder (03) from your
Vertu phone before inserting the battery.
Retain the plastic placeholder for future use. If
you need to remove the battery, insert the
plastic placeholder before replacing the back
cover to make it easier to remove the back
cover.
> Slide the retaining bar (04) towards the top of your
Vertu phone and then pivot upwards.
> Insert the SIM card, ensuring that the bevelled
corner (05) is located top right and the gold
contact area is facing downwards.
> Return the retaining bar to its original position and
slide it towards the bottom of the phone. The
retaining bar should firmly lock into place.
For availability and information on using SIM
card services, contact your SIM card vendor.
This may be the service provider, network
operator, or other vendor.
Keep SIM cards and the back cover release key
out of the reach of small children.
Always switch the phone off and disconnect the
charger before removing the battery.
Do not remove the release tab or the protective
plastic film from the battery as this will damage
the battery.
01
02
03
04
05