User's Manual

Table Of Contents
3.
Finally, close the door making sure it clicks into place.
Charge the phone
The internal battery needs activating prior to first use, and it is recommended to charge the battery at this
point as it may not have been supplied with a full charge. Connect the supplied USB data cable into the
charging port on the side of the phone. Then connect the other end of the cable to the USB port on your
Vertu mains charger.
!
Important: Use only chargers, cables and accessories supplied by Vertu.
If the phone indicates a low charge, do the following:
1.
Connect the supplied wall charger to the wall outlet and then insert the microUSB connector into
your phone.
2. When the battery is fully charged, disconnect the charger from the phone and then from the wall
outlet.
Note:
l You can use the phone while it is charging.
l If the battery is completely discharged, it may take several minutes before the charging indicator is
displayed or before you can make any calls.
l The phone cannot be activated using the Vertu Wireless Powerpack.
Getting started
© 2015 Vertu Corporation Limited. All rights reserved. 12