User's Guide

Table Of Contents
Other ways to charge the battery
You can also charge your phone by connecting it to your computer using the USB cable, or by placing it on
the optional Vertu Wireless Charging Pad.
Note: Your phone charges quicker when connected to the wall charger.
Battery Saver mode
If the battery is running low and you are unable to charge your Constellation, you can use the Battery Saver
feature. This extends battery life by limiting your device's power consumption. Your phone's performance is
reduced when Battery Saver is switched on, and email and other apps may not update until you open
them.
To enable Battery Saver, swipe down with two fingers on any screen and touch Battery saver.
When Battery Saver is enabled, displays on the status bar. Battery Saver automatically turns off when
you charge the phone.
You can also set up your Constellation to automatically switch on Battery Saver when the battery charge
drops below 15% or 5%. To enable automatic Battery Saver, touch Apps> Settings>Battery
saver>Turn on automatically.
Switch the phone on or off
Switch on: Press and hold the Power key until the phone vibrates.
Switch off: Press and hold the Power key, and then touch Power off.
Note: Always remember to power off your phone before removing and inserting a SIM card. This action will
ensure that your network connectivity is restored.
In the unlikely event that your phone stops responding, reboot it. To reboot, press and hold the Power and
Volume Down keys, at the same time, until the phone vibrates. This takes approximately 10 seconds.
Getting started
© 2017 Vertu Corporation Limited. All rights reserved. 12