Product guide

How to Run
XAPP1178 (v2.0) January 23, 2015 www.xilinx.com 15
How to Run
How to Build the Reference Design
This section describes how to build the reference design for both hardware and software.
Before beginning, unzip the reference design into a local directory (referred to as XAPP1178 in
the rest of the steps).
If you want to build the hardware design and SDK workspace instead of using the bitstream and
elf files from the ready_for_download folder, follow these steps.
Create a Vivado Design Tools Project and Generate Bitstream
This section details the steps to start a new Vivado design tools project.
1. Open the Vivado Design Suite.
2. Open the Tcl Console in the Vivado IDE (Click Window->Tcl Console if you do not see it.)
3. In the Tcl Console of the Vivado IDE, change to the mst or sst hw directory:
cd XAPP1178/DP_Tx_Xapp/mst/hw
or
cd XAPP1178/DP_Tx_Xapp/sst/hw
4. Source the given mst.tcl or sst.tcl file based on your requirement to test the MST or
SST protocol respectively.
> source mst.tcl or source sst.tcl
5. Wait until the project is created, output products are generated, design is synthesized and
implemented and the bitstream is generated. Figure 7 and Figure 8 show the address
mapping of all the IP cores with the MicroBlaze™ processor in the system.
X-Ref Target - Figure 7
Figure 7: Base and High Addresses of the IP Cores Present in IP Integrator System for MST Mode