Manualshelf

User's Manual

ManualsBrandsVesper Marine ManualsElectronicsAIS AtoN (Aids-to-Navigation)
12345678910
Page 10
Copyright © 2015, Vesper Marine Ltd. All rights are reserved
To change the port and protocol used by the accept mode, navigate to the Tunnel Accept
Mode page,
Telnet and TCP are the only protocols supported in accept mode. The TCP accept mode IP
address and port combination can be used to connect to the Virtual AIS Beacon using the
configuration software as described in the following section. You must ensure the Virtual AIS
Beacon is configured to use the Ethernet port (default) instead of the serial port. To toggle
between the two modes of operation use the NWK command as described in the NMEA
Command Interface section.