Use & care guide

8
ECO CYCLE
The ECO CYCLE gives you the option of washing dishes
at normal incoming water temperature. When activated, the
ECO CYCLE reduces or eliminates heating time depending
on incoming water temperature.
DELAY START
DELAY START allows you to delay the start of any cycle
by 1 to 24 hours. To activate this feature, press the DELAY
START button and refer to the LED DISPLAY. Each press of
the button corresponds to one hour. Once you’ve reached
the desired hour(s), use the PROGRAM button to select a
wash cycle, then press START/RESET. The LED DISPLAY
will fl ash the hour(s) you selected until the cycle begins.
IMPORTANT
!
!
PRE-WASH
PRE WASH is a convenience feature that allows dishes
to be rinsed, if you don’t have a full load ready to be
washed (preventing food from becoming dried/caked on
the dish surface). It is not necessary to add detergent to
the dishwasher during the PRE WASH cycle. However, due
to the short duration of the PRE WASH cycle (12 minutes
only) make sure the incoming water supply is HOT.
INTENSIVE WASH
The INTENSIVE WASH feature gives you the option of
rinsing dishes at very high temperatures for a longer time.
When activated, the cycle activates a heating element that
will raise the internal water temperature of the dishwasher
to 156°F (69°C) during the rinse cycle.
NOTE ABOUT DRYING
The dishes dry by a “convection” method only.
To speed-up the drying time, it is suggested to
leave the dishwasher door partially open after
the program is complete. This will allow hu-
midity from within to escape. Push the “Door
Open” button and the door pops open to a pre-
set convection drying position.
USE AND CARE GUIDE
CAUTION
!
!
Water temperatures this high can cause severe
burns/scalding. Always exercise extreme care
when opening and/or entering the dishwasher
during the Sani wash cycle.