Instruction Manual

ManualsBrandsVestil ManualsEquipmentAHA-KIT Come-Along kit

rev. 1/10/2013 Come-along, manual

AHA-KIT COME-ALONG KIT FOR HEIGHT ADJUSTMENT

INSTRUCTION MANUAL

Receiving instructions:

After delivery, IMMEDIATELY remove the packaging from the Hook-Base in a manner that preserves the

packaging and maintains the orientation of the product in the packaging; then inspect the product closely

to determine whether it sustained damage during transport. If damage is discovered during the

inspection, immediately

record a complete description of the damage on the bill of lading. If the

product is undamaged, discard the packaging.

NOTES

1) Compliance with laws, regulations, codes, and non-voluntary standards enforced in the location where

the product is used is exclusively the responsibility of the owner/end-user.

2) VESTIL is not liable for any injury or property damage that occurs as a consequence of failing to apply either:

a) Instructions in this manual; or b) information provided on labels affixed to the product.

Neither is Vestil

responsible for any consequential damages sustained as a result of failing to exercise sound judgment

while assembling, installing, using or maintaining this product.

VESTIL MANUFACTURING CORP.

2999 North Wayne Street, P.O. Box 507, Angola, IN 46703

Telephone: (260) 665-7586 -or- Toll Free (800) 348-0868

Fax: (260) 665-1339

www.vestilmfg.com e-mail: sales@vestil.com

Table of Contents

Hazard identification: explanation of signal words…………………………………………………………………… 2

Safety Guidelines……………………………………………………………………………………………………….. 2

Operation ………………………………………………………………………………..........................................3 - 4

Maintenance……………………………………………………………………………………………………………... 4

Limited warranty…………………………………………………………………………………………………………. 5

Summary of content (5 pages)

PAGE 1
rev. 1/10/2013 Come-along, manual VESTIL MANUFACTURING CORP. 2999 North Wayne Street, P.O. Box 507, Angola, IN 46703 Telephone: (260) 665-7586 -or- Toll Free (800) 348-0868 Fax: (260) 665-1339 www.vestilmfg.com e-mail: sales@vestil.
PAGE 2
rev. 1/10/2013 Come-along, manual Hazard Identification--Explanation of SIGNAL WORDS This manual uses SIGNAL WORDS to indicate the likelihood of personal injuries, as well as the probable seriousness of those injuries, if the product is misused in the ways described. Other signal words call attention to uses of the product likely cause property damage.
PAGE 3
rev. 1/10/2013 Come-along, manual Operation: 1. Install the cable loops. The cable loops must be installed around the teletubes of your crane to provide the necessary upper attachment point for the come-along. Twist the cable loop into an “8” and fold the top of the 8 over onto the bottom part of the 8 (this will double loop the cable). Then slide the doubled loop onto the yoke as shown below, and assemble the crane according to the instruction manual.
PAGE 4
rev. 1/10/2013 Come-along, manual FIG. 2B: Operational attachment of come-along to crane Teletube A Cable loop B Short side Long side Step A: Attach the fixed hook to cable loops. Step B: Attach the cable hook to the cable hook attachment bolt. Step C: Attach the pulley hook to the short side of the bottom crane teletube. C FIG. 2C: Ratchet spring Whether moving the handle of the come-along shortens or lengthens the cable depends on the position of the ratchet spring. The come-along is shown in FIG.
PAGE 5
rev. 1/10/2013 Come-along, manual LIMITED WARRANTY Vestil Manufacturing Corporation (“Vestil”) warrants this product to be free of defects in material and workmanship during the warranty period. Our warranty obligation is to provide a replacement for a defective original part if the part is covered by the warranty, after we receive a proper request from the warrantee (you) for warranty service. Who may request service? Only a warrantee may request service.