Instructions / Assembly

Rev. 10/5/2017 APTS, MANUAL

Installing the Casters (Models with –C or –CF Suffix)

If your toolbox includes casters, then the casters must be installed before the toolbox is put into service.

Step 1: Carefully turn the toolbox onto its back to expose the receivers,

which are numbered 1-4 in the diagram (below).

NOTE: How the casters are installed determines how the toolbox rolls

when it is pushed. Installing both rigid casters receivers 1 and 4 (or 2

and 3) causes the toolbox to roll lengthwise. If both rigid casters are

installed in receivers 1 and 2 (or 3 and 4), then the toolbox will roll

widthwise.

Rigid caster

Swivel caster

Step 2: A) Insert the mounting plate of each caster into a receiver. B) Then, insert

a carriage bolt through the holes in the receiver. Tighten a lock nut on the end of

each bolt.

Caster

receiver

Carriage bolt & nut

1 & 4

1 & 2