Manual

12/7/05 09-126-120.doc
V
ESTIL MFG. CO./T&S EQPT. CO. 1 of 8
VESTIL MANUFACTURING CORP.
2999 N. Wayne St., Angola, IN 46703
Ph: 260-665-7586 · Fax: [phone]
E-mail: [e-mail]
· www.vestil.com
MODEL DGD-A & DGS-A
Serial number ____________
Assembly / Installation Instructions ………………..… 2
Operation Instructions ……………………….……….. 2
Routine Maintenance & Safety Checks ………………. 3
Exploded Structural Parts Drawing & BOM ………... 4-5
Troubleshooting …………………………....…………. 3
Safety Label Identification .............................................6
Warranty …………………………………….……..…. 7
WARNINGS AND SAFETY INSTRUCTIONS
Ensure that all employees understand and follow the following.
o Read and understand the owner’s manual before using or servicing
the DGD-A / DGS-A.
o The load must be removed before any work is performed on the
DGD-A / DGS-A.
o Ensure that all safety and warning labels stay in place and are
legible.
o Do not use the DGD-A / DGS-A if any damage or unusual movement
is observed.
o Always watch the arms and the drum carefully when the DGD-A /
DGS-A is in operation.
o Before transporting a drum, raise the unit so the drum is off the
ground. Transport the drum as close to the ground as possible
without hitting the ground.
o The DGD-A / DGS-A is intended for use with only steel drums
o Do not perform any modifications to the DGD-A / DGS-A without the
manufacturer’s approval. Failure to receive authorization for
changes to the equipment could void the warranty.
o Maintenance and repairs are to be done only by personnel qualified
to perform the required work.
WHEN ORDERING
REPLACEMENT PARTS:
We take pride in using quality
parts on the equipment we
manufacture. We are not
responsible for equipment
problems resulting from the use
of unapproved replacement
parts.
To order replacement or
spare parts for this equipment,
contact the factory.
In any communication with
the factory please be prepared
to provide the machine’s serial
number, which is indicated on
the machine dataplate.
RECEIVING INSTRUCTIONS
It is possible that the unit could
incur damage during transit.
Inspect the unit closely when
it arrives. If you see evidence
of damage or rough handling to
either the packaging or to the
product when it is being
unloaded, immediately
make a
note of it on the Bill Of Lading!
It is important that you
remove the product’s packaging
upon its arrival to ensure that
there is no concealed damage
or to enable a timely claim with
the carrier for freight damage.
Also verify that the product
and its specifications are as
ordered.
O
WNER
’
S
MANUAL