Use and Care Manual

Table of Contents Rev. 11/29/2023 E-MT, MANUAL
Table of Contents Copyright 2023 Vestil Manufacturing Co. Page 6 of 7
To maximize the service life of the trolley, routinely clean and lubricate it.
1) Cleaning: Clean the following components with an acid-free solvent at least once per year. Heavy
usage requires more frequent cleaning.
a. Chain
b. Drive Wheels or Gear Teeth
c. Equalizer Pin
e. Fasteners
2) Lubrication: [NOTE: Roller bearings of the trolley are sealed and require no lubrication.]
a. EM-T-C – Apply EP1 grease or the equivalent if the usage environment temperature is in the
range from -20°F to 50°F. EP2 grease is appropriate for temperatures from 30°F to 120°F. Apply
lubricant to the contact surfaces as frequently as necessary to ensure that all teeth are
thoroughly covered.
b. Fasteners and pins – Lubricate fasteners and pins, especially threaded surfaces, with
appropriate lubricants (e.g. anti-seize compound or thread lubricant).
LABELING DIAGRAM
Label content and location are subject to change so your product might not be labeled exactly as
shown. Compare this diagram to your RECORD OF SATISFACTORY CONDITION. Replace all labels that
are damaged, missing, or not easily readable (e.g. faded). Order replacement labels by contacting the
TECHNICAL SERVICE AND REPLACEMENT PARTS DEPARTMENT online at http://www.vestil.com/page-
parts-request.php. Alternatively, you may request replacement parts and/or service by calling (260) 665-
7586 and asking the operator to connect you to the PARTS DEPARTMENT.
E-MT-##
E-MT-##-C
Model
Label No.
E-MT-1
741
E-MT-2
742
E-MT-4
743
E-MT-6
744
E-MT-8
745
E-MT-10
746
Model
Label No.
E-MT-1-C
747
E-MT-2-C
748
E-MT-4-C
749
E-MT-6-C
750
E-MT-8-C
751
E-MT-10-C
752