User guide

1
T & S Equipment Company
2999 North Wayne St., Angola, IN 46703
Ph: [phone] Fax: [phone]
Website: www.tseq.com
Contents
SELF ELEVATING TABLE
MODEL ETS-460
OWNER'S
MANUAL
Revised 02-02 21-126-101
A company dedicated to solving ergonomic and material
handling problems since 1955.
SELF ELEVATING TABLE
MODEL ETS-460
Ergonomic Solutions
WARNINGS & SAFETY INSTRUCTIONS
Read owner's manual completely before operating unit!
• Never load the unit unless you are watching it.
• Do not operate unless all guards are in place and secure.
• Keep hands and feet clear of all moving parts.
• Never exceed the maximum loading capacity of 460 lbs.
• Load must be evenly distributed on table to insure
stability.
• Consult factory for uneven loading.
• Always operate unit on a level surface to insure stability.
• Always apply wheel brakes when unit is not been moved.
• Use caution in moving a loaded cart; avoid obstructions
and floor defects.
• Always be sure that all of the springs in use are securely
attached to their hanger bars.
• Always leave at least four (4) springs in use at all times.
• Remove weight before working on unit.
• Never go under platform if there is weight on unit.
• Use only maintenance parts supplied or approved by the
manufacturer.
• Consult factory if adding or performing any modification
to the original equipment.
• Make sure all operator safety labels are in place (p.4).
• Failure to follow these guidelines may result in personal
injury or death.
RECEIVING INSTRUCTIONS
Every unit is thoroughly tested and inspected prior to
shipment. However, it is possible that the unit may incur
damage during transit. If damage is noticed when unloading,
make a note of it on the BILL OF LADING. Remove all
packing and strapping material, then inspect the unit again for
damage. IF DAMAGE IS EVIDENT, FILE A CLAIM WITH
THE CARRIER IMMEDIATELY!
Warnings And Safety Instructions .................... 1
Receiving Instructions ...................................... 1
Operating Instructions ...................................... 1
Loading Chart................................................... 2
Parts List .......................................................... 3
Warning Label Identification ............................. 4
Limited Warranty/Service Record..................... 5
MODEL NUMBER AND CAPACITY
The model number, serial number and capacity
is inscribed on the nameplate. Please remember to
include these numbers in any correspondence with your
dealer or the factory.
OPERATING INSTRUCTIONS
1) Position the work table near desired work area.
2) Lock back casters.
3) Determine initial total weight of the items that are to be
placed on table.
4) Refer to the provided load chart for the proper number
of springs to use.
5) Remove the front cover and unhook the number of
springs that are not going to be used from the bottom
spring hanger bars. Properly unhooked springs can be
left hanging from the top spring hanger bars.
6) Replace the front cover.
7) Place the previously specified load on table.
8) At the end of each run of parts, remove the front cover
and rehook all 14 springs to the bottom spring hanger bars.
9) Replace the front cover.
E
N
G
L
I
S
H
E
S
P
A
N
O
L
F
R
A
N
Ç
A
I
S