Owner manual

Creation Date: 10/22/07 Revision Date: 10/22/07 44-126-001-001
BJW
TO REMOVE CASTERS FROM COMMERCIAL
SPRING LOADED LADDERS:
1. LAY THE LADDER ON ITS SIDE.
2. REMOVE THE SET SCREW FROM THE LEG.
3. GRIP THE CASTER COVER.
4. TWIST AND PULL THE CASTER ASSEMBLY OUT OF THE LEG.
TO INSERT CASTERS INTO COMMERCIAL
SPRING LOADED LADDERS:
1. LAY THE LADDER ON ITS SIDE.
2. INSERT THE SPRING INTO THE HOLLOW CASTER STEM
BEFORE INSERTING THE STEM CASTER INTO THE CASTER
COVER.
3. PUSH THE CASTER ASSEMBLY STRAIGHT INTO THE HOLE
IN THE END OF THE LEG.
4. LINE UP THE GROOVE IN THE STEM CASTER WITH THE
HOLE IN THE COLAR AND THE HOLE IN THE LEG. (THIS WILL
REQUIRE COMPRESSING THE SPRING.)
5. INSERT THE SET SCREW INTO THE HOLE IN THE COLAR
AND INTO THE LADDER LEG SO THAT IT IS CAPTURED BY
THE STEM CASTER GROOVE.
6. REPEAT FOR EACH CASTER ASSEMBLY.