OPERATING INSTRUCTIONS Parts List Hand Pallet Truck Note: Owner and operator MUST read and understand this operating instructions before use this pallet truck.
Thank you for choosing our pallet truck. For your safety and correct operation, please carefully read the manual before use. NOTE: All of the information reported herein is based on data available at the time of printing. The factory reserves the right to modify its own products at any time without notice or incurring in any sanction. Please verify with the factory for possible updates. 1. GENERAL SPECIFICATIONS Capacity (kg) Max. Fork Height (mm) Min.
the nut (D615) or adjusting screw (D133) is in the proper position. 3.4 If the forks do not elevate while pumping in the RAISE position, turn the nut (D615) or adjusting screw(D133) counter-clockwise until the forks elevate while pumping in the RAISE position. Then check the LOWER and DRIVE position according to item 3.1, 3.2 and 3.3. 4. MAINTENANCE Your pallet truck is largely maintenance-free. 4.1 OIL Please check the oil level every six months. The oil capacity is about 0.3lt.
at the halfway point of the length of the forks. 5.10 Make sure that length of the forks matches the length of the pallet. 5.11 Lower the forks to lowest height when the truck is not being used. 5.12 In other specific conditions the operators should take extra care in operating the truck. 6. TROUBLES SHOOTING No Trouble 1 The forks can not be up the max. height. 2 3 4 5 The forks can not be lifted up. The forks can not be descended. Leaks The fork descends without the release valve worked.
4
List of Handle No. Description Qty. D601 Spring 1 D602 Blade Spring 1 D603 Roller 1 D604 Elastic Pin 1 D605 Elastic Pin 1 D606 Elastic Pin 1 D607 Elastic Pin 1 D608 Control Handle 1 D609 Pull Board 1 Remark No. D610B D610A D611 D612 D613 D614 D615 D616 5 Description Handle Handle Screw Chain Pin Adjusting Bolt Adjusting Nut Elastic Washer Qty.
List of Handle No. Description Qty. D601S Spring 1 D602S Steel Ball 1 D603S Cover 1 D604S Screw 4 D605S Pin 4 D606S Pin 1 D607S Elastic Pin 1 D608S Control Handle 1 D609S Pull Board 1 Remark Only for Type D No. D610S D610AS D611 D612 D613 D614 D615 D616 6 Description Handle Draw - bar Screw Chain Pin Adjusting Bolt Adjusting Nut Elastic Washer Qty.
List of Fork Frame No. D201 D202 D203 D204 D205 D207 D206 D208 D209 D206D D208D D209D D210 D211 D212 D213 D214 D215 Description Screw Oil - holder Rock – arm Elastic Pin Retaining Ring Shaft Joint Pushing Rod Nut Joint Pushing Rod Nut Pin Shaft Shaft Elastic Pin Shaft Frame of Roller Qty. Remark 1 1 1 1 2 2 ONLY for 2 Type A 2 2 2 ONLY for Type B 2 2 2 1 2 2 2 2 No.
8
List of Pump Unit No.
10
