Instruction Manual

1
T & S Equipment Company
2999 North Wayne St., Angola, IN 46703
Ph: 260-665-9521 Fax: [phone]
E-mail: [e-mail]
Website: www.tseq.com
Contents
AUTO-HITE CARTS • MODEL SCSC
OWNER'S
MANUAL
Revised 05-02
A company dedicated to solving ergonomic
and material handling problems since 1955.
AUTO-HITE CARTS
SCSC SERIES
Ergonomic Solutions
WARNINGS & SAFETY INSTRUCTIONS
Read owner's manual completely before operating unit!
• Never load the unit unless you are watching it.
• Stand clear from load while loading and unloading.
• Never exceed the maximum loading capacity inscribed on
the nameplate.
• Load unit as uniformly as possible.
• Consult factory for uneven loading.
• Always operate unit on a level surface to insure stability.
• Always apply wheel brakes when unit is not been moved.
• Use caution in moving a loaded cart; avoid obstructions
and floor defects.
• Remove weight before working on unit.
• Never go under platform if there is weight on unit.
• Use only maintenance parts supplied or approved by the
manufacturer.
• Consult factory if adding or performing any modification to
the original equipment.
• Make sure all operator safety labels are in place (p.4).
PERIODIC MAINTENANCE INSTRUCTIONS
Before Each Use Check For The Following:
1.) Structural deformation of legs or deck.
2.) Unusual noise or binding.
3.) Pivot points for wear.
4.) Rollers for looseness and wear.
5.) Retaining rings at rollers.
6.) Clean off dirt and debris.
7.) Make sure all warning labels are in place and in
good condition. See page 4.
DO NOT USE IF THERE ARE ANY OF THE ABOVE!
RECEIVING INSTRUCTIONS
Every unit is thoroughly tested and inspected prior to
shipment. However, it is possible that the unit may incur
damage during transit. If damage is noticed when unloading,
make a note of it on the BILL OF LADING. Remove all packing
and strapping material, then inspect the unit again for damage.
IF DAMAGE IS EVIDENT, FILE A CLAIM WITH THE
CARRIER IMMEDIATELY!
WARRANTY
This product is warranted for 90 DAYS from date of purchase
to be free of manufacturing defects in material and
workmanship.
This warranty does not cover normal wear of parts or
damage resulting from any of the following: negligent use or
misuse of the product, use or application contrary to
installation instructions, or disassembly, repair or alteration by
any person prior to authorization from a factory representative.
Warnings And Safety Instructions .................... 1
Periodic Maintenance Instructions ................... 1
Receiving Instructions ...................................... 1
Warranty........................................................... 1
Spring Adjustment ............................................ 2
Exploded Drawing & Parts List.........................3
Warning Label Identification .............................4