SUPPORTING BRIDGE CRANE Instruction Manual

04/09/07 28-126-123
V
ESTIL MFG. CO. 1
VESTIL MANUFACTURING CORP.
2999 N. Wayne St., Angola, IN 46703
Ph: 260-665-7586 · Fax: [phone]
E-mail: [e-mail] · Website: www.vestil.com
MODEL - SELF SUPPORTING BRIDGE CRANE
Serial number ____________
Assembly / Installation Instructions ………………..… 2
Anchoring Instructions …………………….……….. .. 3
Routine Maintenance & Safety Checks ……………… 4
Inspection & Testing Procedures (hoists) ...…….…….5-6
Exploded Structural Parts Drawing & BOM ………... 7-8
Warranty …………………………………….……..…. 9
IMPORTANT NOTES, WARNINGS AND SAFETY INSTRUCTIONS
Ensure that all employees understand and follow the following.
* Failure to read and understand this owner’s manual before using or
servicing the Self Supporting Bridge Crane constitutes a misuse of the
product. All persons who will install, use, or care for this product must
be familiar with this material.
o The load must be removed before any work is performed on the Self
Supporting Bridge Crane.
o Ensure that all information / safety / warning labels stay in place and are
legible.
o Do not use the Self Supporting Bridge Crane if any damage or unusual
noise is observed.
o Always watch the hoist and load carefully when the hoist & trolley are in
operation.
o The Self Supporting Bridge Crane must be lagged to the floor before
operating.
o The Self Supporting Bridge Crane is intended for installation / use only on
compacted, improved surfaces. Six inch minimum reinforced concrete in
required.
♦ Do not perform any modifications to the Self Supporting Bridge Crane
without the manufacturer’s approval. Failure to receive authorization for
changes to the equipment could void the warranty.
♦ Maintenance and repairs are to be done only by personnel qualified to
perform the required work. Consideration will not be given for warranty
repair charges without prior written authorization by the manufacturer.
♦ Do NOT use for lifting transporting or supporting humans.
♦ Do NOT use crane as a method of grounding equipment.
WHEN ORDERING
REPLACEMENT PARTS:
We take pride in using quality
parts on the equipment we
manufacture. We are not
responsible for equipment
problems resulting from the use
of unapproved replacement
parts.
To order replacement or
spare parts for this equipment,
contact the factory.
In any communication with
the factory please be prepared
to provide the machine’s serial
number, which is indicated on
the machine dataplate.
RECEIVING INSTRUCTIONS
It is possible that this product
could incur damage during
transit.
Inspect the unit closely when
it arrives. If you see evidence
of damage or rough handling to
either the packaging or to the
product when it is being
unloaded, immediately
make a
note of it on the Bill Of Lading!
It is important that you
remove the product’s packaging
upon its arrival to ensure that
there is no concealed damage
or to enable a timely claim with
the carrier for freight damage.
Also verify that the product
and its specifications are as
ordered.
OWNER’S
MANUAL