Owner manual

Instructions for Assembling the Smoking Shed

Diagram

number

Description

Quantity

1 Roof Assembly 1

2 *Right Side Assembly* 1

3 *Left Side Assembly* 1

4 Vertical Support 1

5 Horizontal Support 4

6 Plastic Panel 2

7 Single-Sided Panel Brackets 2

8 Double-Sided Panel Bracket 1

9 Panel Top Bracket 2

10 5/16 x 2-1/4 inch Roof Fastening Bolt 5

11 5/16 inch Nylock Nut 5

12 #12 x 7/8 inch LG Tek Screw 29

13 #12 x 1-1/4 inch LG Tek Screw 6

14 Rubber-backed washer 6

15 Flat Washer 6

Step 1: Assemble the supporting framework for the plastic panels.

Hardware:

6 6

FIG. 1: Front View of Fully

Assembled Shed

Side

assembly

roof

brackets

* The side assemblies are named “left” and

“right” from the perspective of a person

standin

in front of the shelter.

b.) Slide a horizontal support over the connection tabs on the vertical support;

c.) Use a #12 x 7/8 inch LG Tek screw to fasten the pieces together.

Attach the

horizontal

supports to

the vertical

support as

shown in

photos a &

PAGE 1
Instructions for Assembling the Smoking Shed FIG.
PAGE 2
Step 2: Attach the supporting framework to each of the side assemblies. b a. Position a side assembly (the right side assembly is shown in photo a) close to the supporting structure. b. Slide the free end of each horizontal support over the connecting tabs of the side assembly. c. Fasten the two pieces together with #12 x 7/8 inch LG Tek screws. Repeat steps a through c with the other side assembly. a c Step 3: Attach the roof assembly. a Front bracket hole Rear bracket hole a.
PAGE 3
Step 5: Install the plastic panels. a b c a & b. Slide a plastic panel into the right side of the double-sided bracket. Notice that each panel is covered by a thin sheet of plastic. The protective covering will indicate which side of a panel is the exterior. Remove the plastic covering from both sides of each panel. Insert the panel into the bracket with the exterior side facing outwards. Line up the top of the panel with the dashed white line shown in photo b. c.