Use and Care Manual

- 4 -
23.Type X attachment: If the supply cord is damaged, it must be replaced by a special cord
or assembly available from the manufacturer or its service agent.
24.Do not fill the grinding tank to full otherwise it will cause overload. The material you
gonna to grind one time must cover the long blade in the middle and no more than 2/3 of
the tank. Because this machine needs a space to complete the cycle of the blades and the
material to be grind.
25.Even if grinding stone, it only takes 2 minutes, so don't use it for too long. It takes 5-10
minutes to rest after every 3 minutes of work. If you grinding some hard items, there should
has a interval which is to prevent bearing overheating, damage to the motor. General
grains only need 30s to be ground into powder. If you are not satisfied with the grinding
effect, you can sieve out the coarse particles with a mesh screen and grind it again for finer
powder.
26.To ensure safety, the nut should be tightened before grinding. After long-term use,
blades and carbon brushes need to be replaced if they are worn.
27.The motor of the grinder is the brush motor, the sparks and the odor is normal when the
first several uses. The sparks and the brush frictional odor will disappear after you use the
machine some times later.
You can Grind some rice or tea leaves first for several times to eliminate the odor.
TECHNICAL PARAMETER
MODEL
Capacity
RATINGS
Continuous working time
SX-2A
100g
110V/60Hz
450W
≤5min
230V/50Hz
SX-4A
200g
110V/60Hz
900W
230V/50Hz
SX-6B
300g
110V/60Hz
1100W
230V/50Hz
SX-8B
400g
110V/60Hz
1300W
230V/50Hz
SX-10B
500g
110V/60Hz
1500W
230V/50Hz