FAQ

ManualsBrandsVEVOR ManualsAppliancesCommercial Stand Mixer 20 Qt. 3-Speeds Adjustable Silver Commercial Kitchen Mixer with Stainless Steel

Table Of Contents

Commercial Food Mixer FAQ
- Maintenance:
- NOTE:

Commercial Food Mixer FAQ

Trouble shooting

Trouble

Probable cause

Remedy

The mixing shaft doesn’t rotate

after switch on

Electric connectors are loose

Check he electric circuit,

tighten those loose connectors

Oil leakage

Oil seals are worn out

Replace those oil seals

The raising handle is too tight

Guide ways are corroded

Clean and oil the guide ways

The lead screw, bevel gear and

hand wheel shaft etc is dry

Oil them

Temperature rise of motor is too

high, below speed

Lack of voltage

Check the supply voltage

Over load

Less load

The working speed selected is

too high or agitator is not

suitable

Select a suitable speed and

agitator

The noise of the gearbox is

serious, its temperature is too

high

Lubrication is insufficient

Add or replace the oil

The agitator knocks with the

bowl

The agitator or the bowl is

deformed

Repair or replace deformed

part

Unable to open the machine

Cover opened, bowl lifted down

or emergency stop button

opened

Close the safety cover,bowl lift

up, release the emergency stop

button

Summary of content (2 pages)

PAGE 1
Commercial Food Mixer FAQ Trouble shooting Trouble The mixing shaft doesn’t rotate after switch on Oil leakage The raising handle is too tight Electric connectors are loose high, below speed Check he electric circuit, tighten those loose connectors Oil seals are worn out Replace those oil seals Guide ways are corroded Clean and oil the guide ways The lead screw, bevel gear and hand wheel shaft etc is dry Temperature rise of motor is too Remedy Probable cause Oil them Lack of voltage Check th
PAGE 2
Maintenance: After use each time, an carefully the bowl agitators etc, make sure to keep the machine clear. Lubricate the bowl slide ways occasionally by applying a small amount of oil or grease with the tip of linger. NOTE: The above problems are only common machine failure problems, parts damage and some complex problems can contact our customer service, send an email to Mxiclab@outlook.com, we will reply in the fastest possible time to help solve the problem.