Use and Care Manual

BMD8 SERIES SPIRAL MIXERS
BMD8 series spiral mixers are a new type of kneader. Both the dough arm and bowl are
running that it can raise the mixing speed and efficiency greatly. The machines are equipped
with protect cover, easy operable and safety. They are good looking and easy clean, suitable for
mixing flour in hotels, restaurants and public canteens.
Technical specifications
Model
Voltage
Frequency
Power
IP
Rating
Bowl
volume
Max
capacity
Dimension
mm
BMD8
~110V
60Hz
0.45kW
IPX1
8L
3kg
495×302×385
Operation and Notes
1. Set it on a dry horizontal plane (or support), take it firm.
2. Before use, ensure that power supply corresponds to that required by the machine and
external ground wire is reliably connected.
3. Ensure that flour mixing capacity is lower than the max. flour capacity.
4. Before start, ensure that safe protect cover has be put down.
5. Do not put hands and hard-things into the bowl in running.
6. Do not hold and drag the belts and chains by hand.
Maintenance
1. Continuous run time is not too long, keep the machine used long.
2. After used, clean the machine, as to avoid bacteria growth.
3. The transmission case is packed with special grease that will last for service six months. To
add or replace grease, it is necessary to remove the upper cover.
Note: Before maintenance, the machine must be cut off the power supply.
Trouble shooting:
Trouble
Probable cause
Remedy
The mixing shaft do not rotates
after switch on
Electric connectors are loose
Check the electric circuit tighten those
loose connectors
Square rod tremble
Lock bolts are loose
Tighten those bolts
Temperature rise of motor is too
high, below speed
Lack of voltage
Check the supply voltage
Over load
Less load
The noise of the transmission case
is serious
Lubrication is insufficient
Add or replace the grease
Chains are loose
Tighten the chains
The agitator knocks with the bowl
The agitator the bowl is deformed
Repair or replace deformed part
Warning: It cannot be cleaned by water directly.